Prop Shaft Center Mount - Permanent Solution - Easy to do - Made in Germany


In most cases damage of the propeller shaft center support mount only affects the rubber part of the bearing carrier. Now a very beneficial repair method is available. The rubber is simply replaced without removing the shaft from the vehicle.
Only a few steps are to be done: loosening of the attach bracket, removal of the rubber remains and installation of the new split rubber unit between the ball bearing and the outer ring. Usually the ball bearing is in perfect serviceable condition and this permanent repair is a good alternative.

click to enlarge
click to enlarge

This repair was first designed for Touareg 7L and Cayenne 9PA respectively. Similar repairs are also available for:  Audi Q7 4L,  VW T5 and Audi quattro incl. S/RS.  Even for the new support mount design on 2nd generation Touareg 7P and Cayenne 92A a suitable replacement can be offerred as well.

Our solution may be suitable for other models as well. Contact us to check it out.

If it is confirmed that only the rubber part is worn, our repair will be the most efficient way to rectify the drive shaft center support mount. The repair is a permanent fix good for minimum 5 years and 100.000km but probably much more. The rubber material is a high end silicone which is resistant against more or less anything (e.g. fuel, oil, salt, UV, ozone).